CCS Natural Supreme HV is a solvent based silane-siloxane penetrating sealer designed to protect both horizontal and vertical surfaces from the ingress of water and salts.
Once it penetrates the surface, CCS Natural Supreme HV will produce a hydrophobic bond.
Due to its penetrating capabilities CCS Natural Supreme HV does not change or alter the colour of the surface ensuring the original natural look of the substrate is retained.
Recommended Uses
- To protect and treat masonry, concrete, pavers, natural stone and tile from the ingress of water and water borne chemicals.
- Protection for reinforced concrete from salts and chlorides.
- For use on clean plain or coloured concrete, cement based renders, concrete pavers, clay bricks, sandstone, marble, limestone and travertine.
- Ideal for pre-cast panels, tilt-up panels and wall cladding.
Curing
Allow the sealer to cure for at least 4–6 hours before subjecting to pedestrian traffic and 7 days for vehicular traffic, trolleys, wheel mounted bins or any other equipment that could impact or mark the surface. Please note that whilst the sealer is in the curing phase a slight residue may initially be felt underfoot.
Coverage
Coverage is approximately 5m2 per litre depending on surface porosity. A minimum of two coats applied to saturation, is recommended for effective treatment. A third coat may be required for very porous surfaces.
Surface Preparation
Concrete, Natural Stone and Porous Tile
All surfaces to be treated must be structurally sound and all previous coatings, curing compounds, adhesives, efflorescence or laitance should be removed by abrasive blast cleaning, high pressure water washing or mechanical scrubbing.
Application Guidelines
Concrete, Natural Stone and Porous Tile
CCS Natural Supreme HV should be applied undiluted using a low pressure sprayer, brush, broom, or lambs wool applicator.
If using a low pressure sprayer, ensure that you also work the product into the surface using a lambs wool applicator.
Note: Concrete must be cured for a minimum of 28 days before applying CCS Natural Supreme HV.
- Apply the first coat to saturation point and allow sufficient time for penetration, making sure to fill all voids and surface irregularities.
NOTE: If using a low pressure sprayer, ensure that the product is worked into the surface using a lambs wool or microfibre applicator. Should ponding or pooling occur, immediately wipe off excess product or work the product into the surface. - When the surface becomes touch dry, after approximately one hour, apply a second coat as described in step one (above) again ensuring that no ponding or pooling occurs as this may lead to a patchy appearance and other related issues.
Clean Up
Clean tools and equipment using CCS Solvent.
Precautions
- CCS Natural Supreme HV is not designed as a waterproofing compound.
- Do not thin or dilute the sealer.
- Do not apply on damp or wet surfaces.
- Ensure the sealed surface is protected from moisture for a minimum of six hours after application.
Storage
Store in a bunded area or in an approved flammable store away from direct heat.
Downloads
Features and Benefits
- Provides surface protection against water and salts
- Ideal for horizontal and vertical surfaces
- Natural look
Packaging
CCS Natural Supreme HV is available in 20 litre drums.
For further information consult the Safety Data Sheet (SDS) and read the Technical Data Sheet (TDS) carefully before use. SDS and TDS documents are available in the Resources section of this website and by contacting ACS Customer Service support line on 1800 077 744.
